This article details how to program the
ST324x9I-EVAL board with either 4.3” (MB1046) or 5.7” (MB1063) displays.
Note: Please see the article Overview: Compilers and IDEs for troubleshooting and general information.
IAR and Keil
Program the board using ST-Link Utility. The IAR project must set up to use ST-Link as debugger. Use the menu item "Debug without Downloading" to start debugging after programming.
You can use the
flash option with
make to program STM32 based boards using the ST-Link from the command line:
Compile and flash the complete program:
$ make -f target/gcc/Makefile flash
Compile and flash the internal flash only:
$ make -f target/gcc/Makefile intflash